Tag Archives: Lightning Detection

Boltek LD-250 Relay Interface

boltek

 

 

 

 

The LD-250 Lighting Detector from Boltek has an internal output for a relay interface, the manufactures units are quite expensive, so I decided to make my own.

relay
RLO-10 Boltek Relay Interface

Inside the LD-250 is a 14 way header which connects via ribbon cable to the RLO-10, off eBay I bought the 14 way ribbon cable and IDC cable mount socket for £5.00.

Opening the LD-250 the header JP1 is immediately obvious:

inside

 

 

 

 

 

 

 

 

 

 

 

 

Using my multimeter, the header output pins linked to the front panel LED’s and the operating voltage was quickly found.

diagram

Using a spare strip of veroboard I mounted a magnetically shielded reed relay 5v, with flywheel diode across the coil, and the switched Normally Open reed output to a 2.54mm x 2 pitch connector, I also put veropins in the board so I can select which function I want the relay to operate on, should it be needed in the future.

The reed switch is used to switch 24v DC to an indicating LED and a a PLC input, the total load was measured at 21.49mA, well within the 500mA rating of the reed switch.

The module was placed in a small enclosure:enclosure

 

 

 

 

 

 

 

The ribbon cable was then plugged into JP1 inside the LD-250:

ribbon

 

 

 

 

 

 

 

 

 

 

 

Switching on the Boltek performs a self test of the front LED’s and internal buzzer, as I have used the output from the ‘Close’ LED, the reed relay operated and the mast which was raised, automatically retracted.

All in all the project performs as expected and cost me £7 (enclosure was £2) saving me £58.95 on a factory unit.

New Blitzortung Power Supply

Due to my previous blogs about a dodgy power supply unit (PSU) used for Chatteris Weathers Blitzortung lightning detector, I ordered a low electrical noise PSU off ebay.com, I ordered the 5v PSU on the 5th January, I received a mail confirming dispatch on the 7th January and on the 10th January it arrived from Hong Kong!

I plugged the unit in the detected signal quality is excellent, the PSU was quite expensive, but well worth the money as the performance of the unit is considerable better than before.
2015-01-09 23.54.24 (Medium)
Spot the spelling mistake 🙂

2015-01-09 23.54.48 (Medium)
5v USB at 1A and an output of 8.5v which I have used to power thermostat controlling the temperature in the small equipment room.

2015-01-10 02.16.43 (Medium)
TeraDak unit next to my NAS.

TeraDak PSU
Although ‘smoothing’ is on, the trace is considerably better than anything before it.

signal2
Lightning detection trace, picked up from Scotland, so not that far away.